![]() If you have a torque wrench, tighten it to the spec listed in the owner’s manual. If the oil filter came with a new crush washer for the drain plug, use it to replace the old one. When it stops dripping, clean both the plug and the face of the oil pan.Where is it? As long as you’re looking at the bottom of the engine, there’s only one thing that looks like a drain plug. Use the ratchet wrench and socket to undo the drain plug. Be aware that the stream of oil will initially shoot out about eight inches from the drain hole, then drip straight down, so position the pan accordingly. Slide the drain pan beneath the oil drain plug that’s located at the lowest point on the engine’s oil pan (check the owner’s manual if you can’t find it).If you do, you might not be able to get it off next time. Screw it on until you feel the rubber seal touch the engine, then tighten an additional quarter to half a turn by hand. If the car uses a spin-on oil filter, apply a film of clean oil to the rubber seal.Wipe any old oil off the filter’s mating flange on the engine. Drain the filter into the drain pan, then put the filter in a plastic bag and throw it away. A small amount of oil may run down the engine block. Position the drain pan beneath the filter, make sure the filter isn’t too hot to touch, then unscrew it with an oil filter wrench. You may first need to remove an under-engine shroud or cover to expose the filter. If you need to jack it up or put it on ramps to access the oil filter, do so. Warm up the car for 10 minutes because hot oil drains out better.Rob Siegel What you do: How to change the oil Try to jack up the car so the drain plug is on the low side.Ī paper filter insert whose metal canister (see the eight-spoke circular cap) is directly accessible under the hood. And unless your vehicle has a lot of ground clearance, a floor jack and jack stands or a pair of ramps to get sufficient clearance for both the drain pan as well as for you to access the oil filter.And a funnel, a roll of paper towels and disposable gloves. An oil drain pan, preferably one with a spout on it.Don’t use an adjustable (crescent) wrench it may round the corners. If you can, use a six-point, not a 12-point socket (avoids stripping the plug). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |